Home / Our Product / Detail
bag filter housing,high pressure bag filter housing
Bag hose is a new type of equipment. It is mainly composed of a filter bag, shell, support rack and
Bag hose is a new type of equipment. It is mainly composed of a filter bag, shell, support rack and fixture, measuring devices, etc. The fluid flows from the filter entrance into the filter cartridges, with the miscellaneous quality piece retained on the surface or deep in, while clean fluid runs off from the outlet.
Filters adopt clamps, ordinary flange, fast shackle bolt to lock ears .They are very convenient for operation. With female or sanitary clamp connected in the top cap, it is used to install the gauge or platoon air valve, the inlet and outlet is connected with a flange, silk thread and sanitary clamp.
Bag hose has the following features of small cabbage, obvious filtering effectiveness, simple operation and low cost.
This kind of machine is made of SUS304 or SUS316 stainless steel.
bag filter cage Operation and precautions
Daily use: The filtration system at work should always check the pressure difference between the import and export, when the pressure difference reaches 0.05-0.1Mpa, the filter bag should be replaced in time, so as to avoid over pressure on the filter bag rupture and damage to the support net.
Correctly open the filtered filter cover
Warning: Do not open the lid in case of pressure in the bag filter, otherwise remaining liquid may be spilled and cause fluid loss and personal injury.
Therefore, please strictly follow the following order:
1) close the input valve; outlet pressure, close the output valve.
2) Confirm that the pipe connected with the exhaust valve has been connected to the safety department or the suction port (especially when filtering toxic and corrosive liquids), and then open the exhaust valve to prevent the liquid from damaging the working staff and the surrounding environment and Pollution.
3) Check the pressure gauge to determine the internal pressure is 0, then the bag filter should be separated from the pipe system.
4) With a drain valve, confirm that the drain fluid is received in the recovery area and open the drain valve. When the remaining liquid in the bag filter is exhausted through the drain valve, close the drain valve. This discharge can be done in a pressurized manner (please refer to the pressurized discharge process).
5) Unscrew the cap hanging cap, lift the lid, multi-bag filter to be rotated through a certain angle.
Looking forward to your inquiry for this bag filter cage bag filter housing plastic
Micro filter housing
bag filter cage bag filter for boiler
bag filter cage bag filter housing plastic
bag filters for water bag filter for boiler
The Essentials of Industrial cartridge Filter housings
© Copyright 2018 HANGZHOU FUYANG BONA WATER PURIFICATION EQUIPMENT CO.,LTD